- The brown color is very luxurious.
It weighs one-third compared to the existing standby gear.
It's quite light, so I'm a bit worried about its durability, but I'm satisfied.
Read More - I installed this product on my YAMAHA DT200WR 92. Because the DT200WR has slightly less displacement than other dual-purpose bikes of this age, I chose the 45T (OEM: 42) for acceleration. As expected,...Read More
- Installed on cb400sf Revo ABS 2014.To increase the acceleration feeling, we increased the size of 4 guns from OEM 44 guns to this product 48 guns.Performance was made closer to acceleration as expecte...Read More
- It's more like Bronze than Gold.Read More
- I bought this for my Yamaha YZF-R25.I looked for Sprocket to convert to 415, but I couldn't find another one, so I bought this one.415 itself is a special size that is not being used these days, so it...Read More
- XAM handles more hinges than SUNSTAR, and the target GEAR ratio can be achieved with the Rear sprocket alone.With SUNSTAR, you need to change the Front as well, and it's more expensive if you use a no...Read More
- The Ninja1000 has a low reduction ratio, and I can get into 7th gear or have it embroidered Because it was hard to change the reduction ratio, I dropped 3 units to change the reduction ratio As a resu...Read More
- XAM's Premium Series has a bronze collar for a luxurious look It will give you a completely different impression with a tighter suspensionI wonder if it will weigh less than the OEMBut honestly, Sproc...Read More
- Lighter than the OEM Sprocket of about 900g, with a width of about 200g and a LargeI don't know the effect of Single Body because I changed the number of hinges on the Front Anodized Finishing and hig...Read More
- Along with full power, Chain also spoken, Sprocket also thought together and bought one more thing!I am satisfied with the appearance! I will try another one next time.Read More
- Awesome looking good quality sprocket. Put this on my Gb400 to replace the old and it looks great. There was some difficulty fitting the sprocket as the original nut had to be replaced with something...Read More
- If you dare say it - - ---------------------------------------------------*SEROW225WE (After 5MP1) , SEROW 250, TRICKER, XT 250 XSold separately X. A. M exclusive use Sprocket carrier "PCY" ...Read More
- Willy installed in DJEBEL for practice.At the time of purchasing a car body, 40 danches of the same Manufacturer were attached and Willy could be done as it was, but purchased and installed to earn ev...Read More
- In my case, the normal gear ratio is too low geared SEA BASS - DF 200 We chose 40 dots of 520 Size for RearSprocket of DJEBEL. Compared with 45 NORMAL, it became easier to get on the urban area and ex...Read More
- I liked Rear of WR 250 R.It is extremely ordinary Sprocket which can be installed without any problems.Personally, Sprocket is made of Stainless only, especially in the case of Off car.It is necessary...Read More
- As used in the title, I used it for 420 Size Conversion of RZ50.I think that it was a good Modify because 428 Size has almost no freedom of teeth.Read More
THE LARGEST
SHOP IN JAPAN
EXCLUSIVE COUPONS,
SALE, DEALS
FAST, RELIABLE
SHIPPING