Light Auto Switching SensorSwitchModule Automotive Motorcycle Universal Tunnel
Product # 1530747
(0 reviews)6,456.46 PHP (16,800 JPY)
Delivery Information
No Information acquired.
Product detail
Measurement:38mmX16mmX11mm
BodyMaterial:BlackABSPlastic,Waterproof
Sensor:4.1mmLDR
Most Large Output Power:60wX2
with Double-sided Tape with SensorHolder included
60-step sensitivity adjustment for LightSensor sensitivity
**The daytime running light switch can only be operated by persons with proper electrical training.
*It can be installed by a technician who is proficient in servicing motorcycles. The manufacturer is not responsible for any damages.
*Any disadvantages incurred by the user due to improper use or installation, as well as any warranty for the device, are expressly excluded.
*Axel Jeust complies with the CE standards and OHS regulations to which this device is subject.
*For vehicles with permanent lights, either the headlight or the daylight must be on, so be sure to connect the brown wire and the purple wire as shown in the picture.
*In case of using more than 60W or for multiple lights, please prepare a separate relay and supply electricity to the lights via the relay. The output of this module should be connected to the signal terminal of the relay.
*Conforms to safety standards. (*1It will pass the vehicle inspection without any problem even if it is installed on a motorcycle with constant lighting)
*Please adjust the wiring length by cutting, extending, etc., if necessary according to the sensor installation location. (The sensor has no polarity and can be easily extended.)
*Please note that the product specification may change due to manufacturer reasons.
.
Can be easily dayTimeRunningLight.
Can also be used as Autolite.
Headlight can be turned on, off or automatically switched to Daylight depending on the brightness..
Each has an output of 60 W.
In order to avoid frequent ON/OFF of the light, which is often the case with retrofitted Autolite, the light is turned on instantly from bright to dark and turned off after a pause of 3 seconds from dark to bright, just like the Autolite installed in the Standard Equipment in cars..
This Relay has two outputs, each with a 60 Watt load..
This module switches between Low beam and DayTimeRunningLight via the luminance sensor..
Sensitivity can be adjusted to 60 brightness levels and can be permanently stored.
To ensure safety when entering the tunnel, the switching time from DayTimeRunningLight to Low beam is set to less than 0.5 seconds..
The switching time from Low beam to DayTimeRunningLight is set to about 3 seconds to avoid the influence of scattered light from other road users, street lights, etc..
The Relay is small (38mmX16mmX11mm), so it can be easily processed and installed inside various Headlights and SteelHandlebars..
See you there!
We hope you will enjoy a lot of fun and always a safe journey with this Device!
Points of Attention
* If there may be an instruction manual included, it will be written in Japanese.
NEW ARRIVALS IN USED PARTS FOR
NEW ARRIVALS IN USED PARTS FOR
NEW ARRIVALS IN USED PARTS FOR
New arrivals in used
New arrivals in used
Customer Reviews
There are no Customer Review yet.
New Custom Articles
