Rear will be raised about 1cm.
The ease of bending the corner has increased dramatically.
There is a sense of security.
It is OEMSuspension, but I think it is enough for a medium-sized circuit.
I recommend it!
- Sale
8,474.1 PHP (22,050 JPY) 8,877.63 PHP Save 5%
Webike Point: +221 pt
(84.93 PHP)
Delivery Information
-
Please select product form first.
Product detail
Total NC machined duralumin, anodized
**The image shows the silver anodized specification.
*There may be changes in product specifications due to the manufacturer's reasons..
By changing the suspension rods from the stock suspension rods, the ride height is increased by approximately 12-18mm to accommodate the lack of bank angle.
Please use it as a setting part when the bank angle of the stock body is insufficient or the rear suspension is changed.
It is recommended to install the product at a well-equipped shop
Two colors of highly decorative silver anodized aluminum and gold anodized aluminum are available
Points of Attention
* If there may be an instruction manual included, it will be written in Japanese.
NEW ARRIVALS IN USED PARTS FOR
NEW ARRIVALS IN USED PARTS FOR
NEW ARRIVALS IN USED PARTS FOR
New arrivals in used
New arrivals in used
Customer Reviews
Reviews with image
Fits:KAWASAKI Ninja ZX-25R 20-21
Oct 14, 2021
Helpful?
Fits:KAWASAKI Ninja ZX-25R 20-21
Feb 6, 2021
For adjustment of suspension replacement.
Used to correct lowered ride height due to incompatible suspension.
The amount of change was less than I expected and I think it could have been higher.
In the attached image, I installed it in the opposite direction of the specification, but the amount of change was larger that way. (At the position of Axle, the normal direction +20mm)
The Lever ratio may change, but I use it as it is because it is better than the discomfort caused by the excessive drop in ride height in the regular direction.
The orientation could have been stamped with a narrower gap between the holes, front, arrow etc.
It's a shame that RACINGLINK doesn't have the Black setting that Lowdown has.
I had to put a collar between the end eye, but this was hard to install, I wanted it to be welded.
Helpful?
Fits:KAWASAKI Ninja ZX-25R 20-21
Nov 15, 2020
The height of the Rear was raised and it became like the position of SS.
I bought the Gold color because it is a premise for OHLINS. Personally, I wanted the Black color, but I didn't have a choice. The installation is no problem. The footing is not so bad, but the Position is good. I don't think it is enough for Winding Level, but it is not enough for Circuit.
View DetailHelpful?
New Custom Articles
